Inktray (Guangzhou) Electric Appliance Co., Ltd
+8619806858460

Causes and solutions of non refrigeration of freezer

Sep 15, 2021

Non refrigeration of freezer is a common problem. Let's tell you in detail the reasons and solutions for non refrigeration of freezer.

 

Reasons for non refrigeration of freezer

 

The causes of such failures are:

 

1. Improper adjustment of expansion valve and outlet valve of refrigerator, excessive refrigerant in the system, air in the refrigeration system, poor sealing of valve plate components, wear of compressor cylinder liner piston, etc.

 

2. The high-pressure output buffer pipe in the compressor is broken, or the screw fixing the pipe is loose, resulting in no exhaust of the high-pressure pipe and no suction of the low-pressure pipe. Therefore, although the compressor operates, it does not cool.

 

3. The refrigeration system leaks and the refrigerant runs out. Although the compressor operates, there is no refrigerant evaporation and heat absorption in the system, so the temperature in the refrigerator does not drop.

 

4. The capillary tube is blocked, the refrigerant cannot enter the evaporator to evaporate and absorb heat, and the temperature in the refrigerator does not drop.

 

5. Due to improper welding or use of the freezer, there are leakage points in the refrigeration system. If all the refrigerant in the freezer in the refrigeration system leaks out within a certain time, it will not be cooled.

 

6. Check whether the gear used by the freezer is correct. Different gears have an impact on the power consumption and temperature of the freezer.

 

Solution to non refrigeration of freezer

 

1. In the shutdown state, turn the inlet valve rod counterclockwise to the end, remove the screw on the process port, install the special "alignment wire" for repair, and then install the connecting pipe and pressure gauge. The gauge valve is closed. Rotate the inlet valve rod clockwise for about one turn to make the inlet valve in a three-way state, and observe whether the inlet valve pressure is normal. If the pressure is normal, start the refrigeration compressor of the refrigerator to see if the pressure drops to the normal value. Touch the pipe from the compressor outlet to the condenser with the back of your finger to see if there is an obvious temperature rise. If there is a certain temperature rise and the evaporator pipe is frosted, it is insufficient refrigerant; If there is no heat in the outlet pipe after the pressure drops or it cools again after a while, it indicates that there is ice blockage or dirty blockage in the refrigeration system; If the pressure is similar to that at shutdown. It proves that there is a problem with the valve plate assembly of the refrigerator refrigeration compressor, and the compressor loses its suction and exhaust capacity; If the pressure also drops, but does not fall to the normal value, check whether the evaporator has no frost, virtual frost and condensation.

 

2. Cut the casing, replace the buffer pipe, or tighten the screws.

 

3. First find out the leakage part of the system, conduct welding repair, pressure test and evacuation. After passing the test, add refrigerant to a certain amount. Usually, it shall be subject to the full frost of the evaporator or the rated temperature in the refrigerator.

 

4. The capillary tube or dryer is blocked and the outlet is hot. Therefore, remove it and remove it! In addition, household refrigerators generally have direct cooling type and indirect cooling type. Direct cooling type refers to the purpose of cooling by heat exchange between evaporator (cooling pipe) and freezing and refrigeration chamber directly; Intercooling type refers to that the evaporator (cooling pipe) is separated from the refrigeration and refrigeration room, and a fan blows the cold air into the refrigeration and refrigeration room to achieve the purpose of cooling.

 

5. Refrigeration cannot be achieved without freezer refrigerant. In this case, it is best to ask professionals to carefully check and repair the leakage point, then vacuum and dry, and refill qualified and appropriate amount of refrigerator refrigerant.

 

6. We should choose different gears in different seasons.

 

Summary: the above is the little knowledge about the causes and solutions of non refrigeration of freezers provided to you today. If you encounter similar problems in the future, you can refer to them accordingly. I hope it will be helpful to you.